HEED 3 Product Briefing - ballistecmt.com

HEED 3 - Product Briefing

Models 175-001 and 300-001

Regulator Body – Our simple rugged design utilizes the same time proven technology found in typical regulators used by SCUBA Divers around the world. Our always-on, breathe on demand, balanced single stage regulator is easy to use, maintain and service. HEED 3 can be used in any orientation, even upside down.

Serial Number – Located on the regulator.

Pressure Indicator – Dial Gauge Pressure Indicator has an easy to read, color coated display for at-a-glance pressure check in psi and bar.

Purge Button – Clears the regulator and empties the Air Tank.

Mouthpiece – High Quality silicone mouthpiece.

Refill Port & Cap – Heed 3 is refillable from an air compressor, hand pump or full scuba tank.

3000 PSI Aluminum Cylinder – Original manufacture date is stamped on the neck. The cylinder should be hydrostatically tested every 5 years based on this date.

VIP Sticker – Month and year of the last cylinder visual inspection, required every year when refilling HEED 3 at a dive shop.

Models 200-003 and 300-003A-SW

First Stage Regulator – The first stage reduces the high pressure within the cylinder to an intermediate pressure utilized by the second stage.

Serial Number – Both First and Second Stage Regulators are assigned serial numbers, placed on the back side of each.

Pressure Indicator – Dial Gauge Pressure Indicator has an easy to read, color coated display for at-a-glance pressure check in psi and bar.

Refill Port & Cap – -Heed 3 is refillable from an air compressor, hand pump or full scuba tank.

Mouthpiece – High quality silicone mouthpiece.

Purge Button – Clears the regulator and empties the Air Tank.

Second Stage Regulator – The second stage provides air at ambient pressure and normal breathing through the mouthpiece. Heed 3 can be used in any orientation, even upside down.

On/Off Valve – Twist valve to turn the air supply on and off.

3000 PSI Aluminum Tank – Original manufacture date is stamped on the neck. The cylinder should be hydrostatically tested every 5 years based on this date.

VIP Sticker – Month and year of the last cylinder visual inspection, required every year when refilling HEED 3 at a dive shop.

Burst Disc & Plug Assembly – Protects the product in the event of over pressurization.